|
|
Computational fluid dynamics analysis of influence of different pipe structures on gas mixing uniformity |
ZHENG Jin’ge, CHENG Weiya, WANG Chenxiao, HAO Guizhen, LIU Weifu, GUO Haocheng, ZHAO Yulun, CHEN Ling |
China Institute of Atomic Energy, Beijing 102413 China |
|
|
Abstract Objective Tostudy the influence of pipe structures on the mixing uniformity of airborne effluents from nuclear power plant chimneys. Methods We used the computational fluid dynamics (CFD) method to simulate the velocity distribution and gas mixing in long straight pipes (I type) with square section and circular section, 90° single-bend pipes (L type) with square section and circular section, and 90° double-bend pipes (S type and U type) with square section and circular section. Results For the long straight pipe, due to the lack of flow disturbance caused by structural changes, the mixing effect was not good; when the pipe section was circular, it might take mixing distance 20 times the hydraulic diameter to achieve the uniformity index required by the relevant standard; for the square pipe, the distance might be longer. In the single bend pipe with square section, the velocity uniformity was improved more greatly after the bend, and the tracer gas met the mixing uniformity at a shorter distance (11 times the hydraulic diameter), as compared with the single bend pipe with circular section. For the S-type double-bend pipe, the tracer gas appeared uniformly mixed after a distance 6 times the hydraulic diameter in the square pipe, and 7 times the hydraulic diameter in the circular pipe. For the U-type double-bend pipe, the gas in the square pipe also achieved uniform mixing ata shorter distance downstream, and the airflow showed greater disturbance when passing through the bend.Conclusion The CFD method can make an accurate prediction for the change patterns of gas mixing uniformity in pipes with different structures, and can partially replace physical experiments to study the factors affecting the mixing uniformity of airborne effluents from the chimney of nuclear power plants.
|
Received: 22 September 2021
|
|
|
|
|
[1] 卢正永. 核设施烟囱和管道气载放射性排放物的取样监测——美国新标准介绍(三)[J]. 辐射防护通讯,2003,23(3):40-42. DOI: 10.3969/j.issn.1004-6356.2003.03.008 Lu ZY. Sampling and monitoring releases of airborne radioactive substances from the stacks and ducts of nuclear facilities—introduction of a new standard of the America: part III[J]. Radiat Prot Bull, 2003, 23(3): 40-42. DOI: 10.3969/j.issn.1004-6356.2003.03.008 [2] ISO. ISO 2889—2010 Sampling airborne radioactive materials from the stacks and ducts of nuclear facilities[S]. Switzerland: [s.n.], 2010: 110. [3] Anand M, McFarland AR, Rajagopal KR. Gas mixing for achieving suitable conditions for single point aerosol sampling in a straight tube: experimental and numerical results[J]. Health Phys, 2003, 84(1): 82-91. DOI: 10.1097/00004032-200301000-00007 [4] Zhang HF, Ahmadi G. Aerosol particle transport and deposition in vertical and horizontal turbulent duct flows[J]. J Fluid Mech, 2000, 406: 55-80. DOI: 10.1017/S0022112099007284 [5] 中华人民共和国国家质量监督检验检疫总局, 中国国家标准化管理委员会. GB/T 33582—2017 机械产品结构有限元力学分析通用规则[S]. 北京: 中国标准出版社, 2017: 14. General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China, Standardization Administration. GB/T 33582—017 General principles of structural finite element analysis for mechanical products[S]. Beijing: Standards Press of China, 2017: 14. [6] Schwer LE. An overview of the PTC 60/V&V 10: guide for verification and validation in computational solid mechanics[J]. Eng Comput, 2007, 23(4): 245-252. DOI: 10.1007/s00366-007-0072-z [7] McFarland AR, Anand NK, Ortiz CA, et al. A generic mixing system for achieving conditions suitable for single point representative effluent air sampling[J]. Health Phys, 1999, 76(1): 17-26. DOI: 10.1097/00004032-199901000-00004 [8] McFarland AR, Gupta R, Anand NK. Suitability of air sampling locations downstream of bends and static mixing elements[J]. Health Phys, 1999, 77(6): 703-712. DOI: 10.1097/00004032-199912000-00015 [9] Seo Y. Degree of mixing downstream of rectangular bends and design of an inlet for ambient aerosol[D]. Texas: Texas A&M University, 2004. [10] 钱丛昊. 燃煤电厂排放烟气流速与气体污染物排放量测量方法的研究[D]. 南京: 东南大学, 2019. Qian CH. Research on measurement method of flue gas velocity and gas pollutant emission from coal-fired power plants[D]. Nanjing: Southeast University, 2019. [11] 董信芳, 李航, 丁世海, 等. “华龙一号”核电厂烟囱气态流出物取样系统验证的试验与分析[J]. 中国辐射卫生,2018,27(1):52-57. DOI: 10.13491/j.cnki.issn.1004-714X.2018.01.014 Dong XF, Li H, Ding SH, et al. Verification for the representative sampling system of “Hualong I” NPP gaseous effluent: test and analysis[J]. Chin J Radiol Health, 2018, 27(1): 52-57. DOI: 10.13491/j.cnki.issn.1004-714X.2018.01.014 [12] 叶涛. 多组分粉体混合过程的理论分析与实验研究[D]. 武汉: 武汉理工大学, 2009. Ye T. Theoretical analysis and experimental study for process of multicomponent powders mixing[D]. Wuhan: Wuhan University of Technology, 2009. [13] 程攀攀, 王海宁, 梅力, 等. 颗粒粉尘在水平管道内运移的三维数值模拟[J]. 环境工程学报,2017,11(10):5457-5464. DOI: 10.12030/j.cjee.201612149 Cheng PP, Wang HN, Mei L, et al. 3D simulation on transporting of particle dust in horizontal duct[J]. Chin J Environ Eng, 2017, 11(10): 5457-5464. DOI: 10.12030/j.cjee.201612149 [14] Kelbaliev GI, Ibragimov ZI, Kasimova RK. Deposition of aerosol particles in vertical channels from an isotropic turbulent flow[J]. J Eng Phys Thermophys, 2010, 83(5): 908-916. DOI: 10.1007/s10891-010-0413-4 [15] Yin ZQ, Li XF, Bao FB, et al. Thermophoresis and Brownian motion effects on nanoparticle deposition inside a 90° square bend tube[J]. Aerosol Air Qual Res, 2018, 18(7): 1746-1755. DOI: 10.4209/aaqr.2018.02.0047 [16] Dai ZP, Yin ZQ. Flow and deposition characteristics of nanoparticles in a 90° square bend[J]. Thermal Sci, 2015, 19(4): 1235-1238. DOI: 10.2298/TSCI1504235D [17] 杨光俊, 丁力, 郭照冰. 基于CFD方法的燃煤电厂烟气排放数值模拟[J]. 环境科学研究,2017,30(12):1934-1943. DOI: 10.13198/j.issn.1001-6929.2017.03.51 Yang GJ, Ding L, Guo ZB. Numerical simulation of flue gas emissions from coal-fired power plants using computational fluid dynamics method[J]. Res Environ Sci, 2017, 30(12): 1934-1943. DOI: 10.13198/j.issn.1001-6929.2017.03.51 [18] 陈建利, 王洪凯, 李建发, 等. 核电厂通风系统中压差测量问题分析及解决建议[J]. 中国辐射卫生,2019,28(4):433-435,439. DOI: 10.13491/j.issn.1004-714X.2019.04.023 Chen JL, Wang HK, Li JF, et al. Analysis and solution of the differential pressure measurement problem in the ventilation systems of nuclear power plants[J]. Chin J Radiol Health, 2019, 28(4): 433-435,439. DOI: 10.13491/j.issn.1004-714X.2019.04.023
|
|
|
|